Sucrose Hydolysis by Sucrase

 

Sucrose Hydrolysis Using Sucrase

INTRODUCTION:

In this lab, you will demonstrate the production of the enzyme sucrase (invertase) by yeast. The enzyme sucrase catalyzes the hydrolysis of the disaccharide sucrose to invert sugar. Invert sugar is a mixture of glucose and fructose, which are both monosaccharides. Yeast cannot directly metabolize (ferment) sucrose. For the yeast to utilize sucrose as an energy source, it must first convert it to the fermentable monosaccharides glucose and fructose.
Benedict’s solution is a test reagent that reacts positively with simple reducing sugars. All monosaccharides and most disaccharides are reducing sugars, possessing a free carbonyl group (=C=O). Sucrose is an exception in that it is not a reducing sugar. A positive Benedict’s test is observed as the formation of a brownish-red cuprous oxide precipitate. A weaker positive test will be yellow to orange. Both glucose and fructose test positive with benedict’s solution, sucrose does not.

MATERIALS NEEDED:

*Yeast filtrate solution
one 7 gram package active dry yeast per 80 mL distilled water
Ring stand and ring to hold funnel
Filtering funnel
Filter paper (fast speed)
**5% sucrose solution
5 grams sucrose per 95 mL distilled water
***5% glucose (dextrose) solution
5 grams dextrose per 95 mL distilled water
Benedict’s qualitative solution
Distilled water
Five 10-mL graduated cylinders (one for each solution)
7 test tubes 18 x 150 mm
Test tube holder
Test tube rack
2 400-mL beakers
Hot plate

PRE-LAB:

* To prepare a yeast filtrate solution, mix one package of active dry yeast with 80 mL of distilled water. Let stand for 20 minutes, stirring occasionally. Filter the resulting suspension and save the filtrate solution. This is your invertase extract. Refrigerate the extract if held overnight. Approximately enough for 8 labs.

**To prepare a 5% sucrose solution, dissolve 5 grams of sucrose in 95 mL of distilled water. This should be prepared shortly before use. Approximately enough for 4 labs.

***To prepare a 5% glucose solution, dissolve 5 grams of dextrose (this is the name used when dry) in 95 mL of distilled water. This should be prepared shortly before use. Approximately enough for 9 labs.

PROCEDURE:

1. Label 3 test tubes A1, A2, and A3, and place in the test tube rack. Place into the test tubes as follows:

    • Into tube

A1

    • , place

10 mL

    • of 5% sucrose solution.

Into tube A2, place 10 mL of 5% sucrose solution and 4 mL of invertase extract.

Into tube A3, place 10 mL distilled water and 4 mL of invertase extract.

Thump the tubes to mix.

2. Put approximately 250 mL of 30 to 35 oC water into a 400-mL beaker. Incubate the three tubes in this warm water bath for 35 minutes.

3. Label 4 test tubes B1, B2, B3 and B4, and place in the test tube rack. Place 5 mL of Benedict’s qualitative solution into each tube. Now transfer to the B tubes as follows:

    • Into tube

B1

    • , transfer the contents of tube

A1

    • .

Into tube B2, transfer the contents of tube A2.

Into tube B3, transfer the contents of tube A3.

Into tube B4, place 10 mL of 5% glucose solution.

Thump the tubes to mix.

4. Place tubes B1, B2, B3, and B4 into a boiling water bath. CAUTION: do not let the bath boil hard. Keep it just at the boiling point. After 3 or 4 minutes, remove the tubes and note whither any change is evident.

QUESTIONS AND OBSERVATIONS:

1. Did tube B1 test positive or negative?

2. What does this show?

 

3. Did tube B2 test positive or negative?

4. What does this show?

5. Did tube B3 test positive or negative?

6. What does this show?

 

7. Did tube B4 test positive or negative?

8. What does this show?

 

 

 

Knowing the Elements

Knowing the Elements

Choose one element from the periodic table. (You may not select an element that someone else has already selected, and the element must be found in living things!) Use library books or the website on the back of this sheet to find the information asked for below and to write a 1-2 page paper on that element. Your paper must include the following information to receive credit:

v Name of the element?

v Element’s symbol?

v Family the element is found in?

v Period the element is found in?

v Atomic number of the element?

v Atomic Mass of the element?

v Number of protons?

v Number of neutrons?

v Number of electrons?

v Number of electrons in the outermost energy level?

v Is the element a metal, nonmetal, transition element?

v Is the element inert (nonreactive) or reactive?

v What are the other chemical properties of this element (appearance, state of matter, etc.?

v What are some uses by living things for this element?

v Where is this element found inside of living things and in what amount is it present?

 

***Be sure to answer all questions about the element in your paper. Go to other websites if you need to find more information.

Helpful Links:
Http://www.webelements.com/webelements/scholar/index.html
Http://www.chemicalelements.com
Http://www.webelements.com

BACK

 

 

Chemical Bag of Tricks

 

 

 

 

Chemical Bag of Tricks 

 

 

Introduction:

 

A pH indicator is a chemical compound that is added in small amounts to a solution so that the pH (acidity or basicity) of the solution can be determined visually. Hence a pH indicator is a chemical detector for hydronium ions (H3O+) or hydrogen ions (H+) on the pH scale.  Normally, the indicator causes the color of the solution to change depending on the pH.  At 25 degrees Celsius, considered the standard temperature, the pH value of a neutral solution is 7.0. Solutions with a pH value below 7.0 are considered acidic, whereas solutions with pH value above 7.0 are basic.

 

Objectives:

  • to observe chemical reactions.
  • to observe changes in pH.
  • to do a burning splint test to check for oxygen production.

Materials:

 

  • sandwich size zip top bag (3 per group)
  • 2 plastic spoons (3 per group)
  • 2 tbsp calcium chloride (3 per group)
  • 2 Tbsp. baking soda (3 per group)
  • 1 test tube of water (3 per group)
  • 30 mL of Phenolphthalein*
  • matches
  • wooden splints
  • goggles, gloves, lab apron

 

* You can substitute  Phenolphthalein with Cabbage Juice.  Follow instructions for Cabbage Juice as indicated.

 

 

Procedure Bag 1:

  1. Place 2 tsp of baking soda into the bag.
  2. Add 30 mL of Phenolphthalein to the bag. (Skip this step if you are using Cabbage Juice)
  3. Massage the bag to mix the contents.
  4. VERY CAREFULLY – lower the test tube containing 30 mL of water upright  into the bag.  (OR Lower a small cup or beaker with 50 ml of Cabbage Juice as a substitute). Do not let any spill out.
  5. Have a student help you hold the test tube by squeezing the test tube gently from the outside of the bag while you squeeze the excess air out and seal the bag.
  6. Hold the test tube and bag up and slowly spill the water out of the test tube (while the bag is still sealed).  The contents will turn bright pink. Cabbage Juice will turn greenish blue for a base and purplish for neutral, pink for acid
  7. Pass the bag around and have other students look at and feel the contents of the bag.  At this point, they will see the baking powder dissolving and the contents turning pinker.

Procedure Bag 2:

  1. Place 2 tsp of calcium chloride into the bag.
  2. Add 30 mL of Phenolphthalein to the bag. (Skip this step if you are using Cabbage Juice)
  3. Massage the bag to mix the contents.
  4. VERY CAREFULLY – lower the test tube containing 30 mL of water upright  into the bag.  (OR Lower a small cup or beaker with 50 ml of Cabbage Juice as a substitute) Do not let any spill out.
  5. Have a student help you hold the test tube by squeezing the test tube gently from the outside of the bag while you squeeze the excess air out and seal the bag.
  6. Hold the test tube and bag up and slowly spill the water out of the test tube (while the bag is still sealed).  The contents will turn bright pink and start to get warm. Cabbage Juice will turn greenish blue for a base and purplish for neutral, pink for acid
  7. Pass the bag around and have students look at and feel the contents of the bag.  At this point, they will see the calcium chloride dissolving and the contents turning pinker and getting warmer.

Procedure Bag 3:

  1. Place 2 tsp of baking soda into the bag.
  2. Place 2 tsp of calcium chloride.
  3. Add 30 mL of Phenolphthalein . (Skip this step if you are using Cabbage Juice)
  4. Massage the bag to mix the contents.
  5. VERY CAREFULLY – lower the test tube containing 30 mL of water upright  into the bag.  (OR Lower a small cup or beaker with 50 ml of Cabbage Juice as a substitute)  Do not let any spill out.
  6. Have a student help you hold the test tube by squeezing the test tube gently from the outside of the bag while you squeeze the excess air out and seal the bag.
  7. Hold the test tube and bag up and slowly spill the water out of the test tube (while the bag is still sealed).  The contents will turn bright pink. Cabbage Juice will turn greenish blue for a base and purplish for neutral, pink for acid
  8. Pass the bag around and have students look at and feel the contents of the bag.  At this point, they will see the baking powder and calcium chloride dissolving, foaming, bubbling, instead of pink, it will become clear/white, and the bag will be warm.  As the bag is passed around, it will start to inflate and puff out.

At this point, you will have all 3 bags on your table.  You can have the students compare the 3 bags and discuss what is the same, what is different, why it was important that you did the same procedure for each bag etc.  Have students try to guess why the 3rd bag is puffy and not pink, etc.

 

 

Procedure – Part 2:

  1. After you have discussed what happened in the three bags, light a match for your group.
  2. While someone holds the wooden splint,  light the splint with the match.
  3. Have another student hold the 3rd bag.
  4. Tell the student to open the bag then you will quickly place the burning splint into the bag.

 

 

Observations Part 1:

 

Color? Heat Produced? Foam or Bubbles? Gas?
Bag 1
Bag 2
Bag 3

 

Observations – Part 2

 

What happened when you placed the splint into the 3rd bag? Why? 

 

 

Analysis and Results:

 

  1. Was there a change in pH?  How do you know?
  2. What happened to the contents of the bags?
  3. Without opening the bags, how can you tell if a gas was produced?
  4. This equation tells us what chemical reaction happened in the bag.  Identify and count the elements on each side of the “yield” sign:

2NaHCO3 + CaCl2 ———–> CaCO3  + 2NaCl  + H2O + CO2

  1. Place a CIRCLE around the Calcium Chloride.  Place a SQUARE around the Salt. Place a TRIANGLE around the Water.
  2. What gas was produced in this reaction?
  3. Was there a change in temperature?  How can you tell?

Teacher Notes:

  • You might want to use more sturdy bags if you pass them around. As the students massage the bag, small tears in the bag may occur.  The 3rd bag may burst, it gets pretty full and tight.
  • The Phenolphthalein turns pink in a base and clear for an acid/neutral.
  • Cabbage Juice will turn greenish blue for a base and purplish for neutral, pink for acid
  • Do NOT  do a flame test for bags 1 & 2, it will ignite.  (Phenolphthalein is flammable)
  • Click for MSDS info for  Phenolphthalein : https://fscimage.fishersci.com/msds/96382.htm

This lab was modified from the original lesson:  http://www.science-house.org/learn/CountertopChem/exp5.html

 

BACK